BASiQ-FT
Main features
• VAV unit for flow measurement in demand-controlled solutions
• Digital display for easy setting
• Modbus-RTU as standard
• Included as components in VAV system ControlAir BAS
• Available in both circular and rectangular version
Description
• The BASiQ product range is designed for energy-saving purposes and used to control air volumes in e.g. schools, shops, offices and conference rooms.
• BASiQ-FT is a measuring unit intended to measure air flow in ducts. The measuring unit can be connected to a balancing damper that regulates an equal air flow.
• The product is primarily used in demand-controlled solutions, connected to a BMS, or alternatively installed for stand-alone operation with other BASiQ dampers and Modbus RTU as communication protocol.
• The measuring unit features a user friendly interface with digital display, manufactured by Gruner.
Material options and finishes:
• Galvanized sheet steel (standard)
• Powder coated finish.
Circular sizes (mm):
Ø100 / Ø125 / Ø160 / Ø200 / Ø250 / Ø315 / Ø400 / Ø500 / Ø630
Rectangular sizes:
Products in rectangular version are supplied in specific steps within a standard span of W x H dimensions. starting from from 200 x 100 mm (min) to 1600 x 700 mm (max). See product sheet for the specific combinations.
Alternative dimensions can be offered on special order.
Actuator brand (comparable options):
• Belimo
• Gruner (digital display)
• Siemens
• Product in standard version comes with housing of galvanized sheet steel with a measuring rod of aluminium but can also be ordered in painted versions.
• All products meet corrosivity class C3 with a house in density class C.
• Dampers in the series meet pressure class A.
• Circular products are equipped with gaskets of EPDM rubber.
• Rectangular products are equipped with joint flange profiles for D-type (Drive) or rectangular joint slide profiles/rail. Rails and sealing are not included.
• Circular products have nipple dimensions with rubber gaskets and are mounted with a sliding muff (female slide-in coupling).
• Circular products can be installed in any position and require no maintenance.
• Rectangular products are based on the ordered WxH measurements, which must be taken into account when mounting.
• Rectangular products in standard version come with joint flange profiles for D-type (Drive) or rectangular joint slide profiles/rale. Rales and sealing are not included.
• Rectangular products can also come with frame profiles for bolted assembly (must be specified when ordering).
• In order for the product to provide sufficient measuring accuracy, a straight section of duct must be maintained before the product in air flow direction. This must be taken into account when mounting, see the products operation and maintenance documentation for specific requirements.
• The products are not intended for use in cold or aggressive environments.
• The products may only be installed by authorized personnel. All
rules and regulations issued by authorities in the country of usage
must be followed during installation.
• The products are intended for 24 V supply and must be connected
via protective transformer.
• All wiring must be done with the power supply disconnected.
• When installing, space should be reserved for access to the device's actuators and/or readability of units equipped with a display.
• The required flow range, between min and max value, is set at the factory, or alternatively on-site via built-in potentiometers.
• Please see the products operation and maintenance documentation for detailed information on mounting, connection and commissioning.